EFFECTS // ROBLOX STUDIO
How to make a smoke plume in Roblox Studio
In Roblox Studio, one ParticleEmitter plays a smoke plume that leans with the wind and loops every 4 seconds. Upload your 1024 px sheet with 64 frames, set FlipbookLayout to Grid8x8 and FlipbookMode to Loop.
- Godot 4 Available
- Unity Manual setup
- Unreal Engine Manual setup
- Roblox Studio Manual setup
- three.js Available
A draft compile is from $0.05, and new accounts start with $5 of usage.
01 // WHAT YOU GET
What you get for smoke plume in Roblox Studio
The smoke plume rises from a source on the ground and leans with the wind, about 7 m wide and 10.8 m tall. It loops every 4 seconds, so it can run for as long as something keeps burning. The lighting sheets let your engine relight it from any sun angle.
You get three PNG sheets of 64 frames, a layout.json with the timing, and previews, which you combine into one texture for a ParticleEmitter.
02 // BY HAND TODAY
Set up the smoke plume in Roblox Studio by hand
- Ask your agent for the effect (for example "a chimney smoke plume leaning to the left that loops") with
export.tile_px = 128, so each 8 x 8 sheet is 1024 x 1024 px, the largest image Roblox keeps. - A ParticleEmitter takes one texture, so pack the smoke into one image: ask for
export.packto write the light from above (green ofmain_pos.png) into RGB and opacity (alpha ofmain_pos.png) into alpha. - Upload the image in the Asset Manager and paste its id into the Texture of a ParticleEmitter.
- Set FlipbookLayout to Grid8x8 and FlipbookMode to Loop, with FlipbookFramerate at 16, so the smoke plume loop runs at its real speed.
- Set LightInfluence to 1 so the smoke takes the scene light, and keep LightEmission at 0. Set Size to the meters per tile in
layout.jsonconverted to studs, a little over 39 studs for the smoke plume.
03 // ADJUST IT
Adjust the smoke plume for your scene
Use it over burning wrecks, chimneys and distant fires. Ask your agent for less lean on a calm day, thicker smoke for burning fuel or white steam instead of grey smoke.
04 // SETTINGS
Settings in the smoke plume spec
A steady smoke source and a sideways wind make the lean, and the loop settings blend the end into the start.
Ask your agent to change these and compile again; the full smoke_plume spec lists every value.
How do I get a smoke plume effect for Roblox Studio?
Start from smoke_plume and ask your agent for a leaning chimney smoke plume that loops. Play the compiled texture in Roblox Studio.
How do I make a Roblox smoke plume flipbook loop continuously?
Set FlipbookMode to Loop and FlipbookFramerate to 30, keep new particles spawning and give each particle a Lifetime of at least one loop.
How do I make a realistic smoke plume in Roblox Studio?
Use a simulated plume instead of painted particles. A steady smoke source and sideways wind create the lean while loop settings blend the end into the start.
How many frames does the Roblox Studio smoke plume use?
The smoke plume compile spreads 64 frames over a 4 s loop. Slow smoke hides a low frame rate well and frame blending smooths the motion.
Compile your first effect
You pay per compile and see the price before it runs. New accounts start with $5 of usage.