EFFECTS // ROBLOX STUDIO
How to make a smoke column in Roblox Studio
In Roblox Studio, one ParticleEmitter plays a smoke column that climbs and thins for 5 seconds after a blast. Upload your 1024 px sheet with 64 frames, set FlipbookLayout to Grid8x8 and FlipbookMode to OneShot.
- Godot 4 Available
- Unity Manual setup
- Unreal Engine Manual setup
- Roblox Studio Manual setup
- three.js Available
A draft compile is from $0.05, and new accounts start with $5 of usage.
01 // WHAT YOU GET
What you get for smoke column in Roblox Studio
The smoke column is the smoke left after a burst. It climbs, spreads and thins out over 5 seconds, about 8.2 m wide and 9.9 m tall, and ends once it has faded. Play it right after an explosion so the scene does not snap back to clear air.
You get three PNG sheets of 64 frames, a layout.json with the timing, and previews, which you combine into one texture for a ParticleEmitter.
02 // BY HAND TODAY
Set up the smoke column in Roblox Studio by hand
- Ask your agent for the effect (for example "the smoke that hangs after an explosion, played once") with
export.tile_px = 128, so each 8 x 8 sheet is 1024 x 1024 px, the largest image Roblox keeps. Also ask forexport.pacing = "even": OneShot spaces the frames evenly over Lifetime, and the example spends more frames on its fast start. - A ParticleEmitter takes one texture, so pack the smoke into one image: ask for
export.packto write the light from above (green ofmain_pos.png) into RGB and opacity (alpha ofmain_pos.png) into alpha. - Upload the image in the Asset Manager and paste its id into the Texture of a ParticleEmitter.
- Set FlipbookLayout to Grid8x8 and FlipbookMode to OneShot with Lifetime 6 and Rate 0, then call
Emit(1)when the blast ends. - Set LightInfluence to 1 so the smoke takes the scene light, and keep LightEmission at 0. Set Size to the meters per tile in
layout.jsonconverted to studs, a little over 35 studs for the smoke column.
03 // ADJUST IT
Adjust the smoke column for your scene
Pair it with the fireball or the impact. Ask your agent for a longer hang time, a darker column for burning fuel or a lower, wider cloud for a ground blast.
04 // SETTINGS
Settings in the smoke column spec
A burst of warm smoke is pushed upward for 0.8 s, then swirl, turbulence and fade shape the climb. Front pacing gives the fast early rise more frames.
Ask your agent to change these and compile again; the full smoke_column spec lists every value.
How do I get a one shot smoke column effect for Roblox Studio?
Start from smoke_column and ask your agent for smoke that rises after an explosion and plays once. Play the compiled texture in Roblox Studio.
How do I play the Roblox smoke column flipbook only once?
Set FlipbookMode to OneShot, Rate to 0 and Lifetime to 6 s, then call Emit(1) from a script after compiling with even pacing.
How do I make a realistic smoke column in Roblox Studio?
Use a simulated column instead of painted particles. A warm smoke burst rises for 0.8 s before swirl, turbulence and fade shape the climb.
How many frames does the Roblox Studio smoke column use?
The smoke column compile spreads 64 frames over a 6 s clip. Slow smoke hides a low frame rate well and frame blending smooths the motion.
Compile your first effect
You pay per compile and see the price before it runs. New accounts start with $5 of usage.