meshfx // HOLES
How to fill holes in a mesh
You fill a hole by selecting the open boundary edges around it in your 3D editor and closing them: one face for a small, flat gap, a grid fill for a round or larger hole, and a bridge between two edge loops for a gap between parts. Triangulate any big new face, then recalculate normals.
pyrofx effects work today, and new accounts start with $5 of usage.
meshfx measures faults, checks repairs and makes LODs for a triangle budget. meshfx runs on the hosted API: try it in the Playground.
- A hole is a loop of edges with faces on one side only
- One face for a small gap, a grid fill for a large hole
- Check normals and UVs on the patch
01 // HOW TO
Close a hole by hand
- Select the boundary edges. Use Select Non-Manifold limited to boundaries, or click one edge of the hole and select its loop.
- If the hole is a hairline crack where two rows of vertices nearly touch, merge by distance first; the crack often closes without any new face.
- For a small, flat hole, make one face from the loop (Fill or Make Face), then triangulate it if it has many sides.
- For a round or larger hole, use Grid Fill, which spans the loop with quads that follow the edges around it. Most grid fills need an even number of edges around the hole.
- For a gap between two parts, select the two facing edge loops and run Bridge Edge Loops. Loops with the same edge count give the cleanest faces.
- Recalculate normals, check the UVs on the patch, and bake (precompute) the texture over it if the patch shows.
meshfx measures holes, flipped faces and non-manifold edges. Each repair is checked against the source and undone with a warning if it moves the surface too far. Hosted meshfx runs are available in the Playground.
02 // LARGE HOLES
Large holes and scanned models
A big hole in a curved surface needs more than one face, or the patch shades flat and dents the silhouette. Fill it with a grid, then relax or smooth the new vertices so they follow the curve around them.
A photogrammetry scan can have dozens of holes. Past a handful, rebuilding the surface with a remesh or retopology is often faster than patching each one. Cleaning up a 3D scan covers the full pass.
How do I close holes in a 3D mesh?
Select the boundary loop around the hole and fill it: one face for a small hole, a grid fill for a large one. Recalculate normals afterward.
How do I fill mesh holes without creating bad topology?
Use a grid fill or a bridge instead of one large face, keep the edge count around the hole even and match the size of surrounding faces.
How do I repair a large hole in a game asset?
Grid fill it, then smooth the new vertices onto the curve so the silhouette holds. Compile textures over the patch if the area is visible.
How do I bridge edge loops to close a gap?
Select both open loops, ideally with the same number of edges and run Bridge Edge Loops. Add cuts in the bridge if the gap is long.
Why does remeshing make holes in my model?
A voxel remesh opens holes where a part is thinner than the voxel size. Lower the voxel size or thicken the thin parts before you remesh.
Explore meshfx outputs
Inspect compiled meshfx outputs and their reports. Hosted meshfx runs are available in the Playground.